p>Special Mentions: • Relocation provided • Occasional travel expected • Interviews will include a technical assessment • Responsibilities include but are not limited to: • Electronic architecture development of motor controllers • Schematic capture and PCB layout in Altium • Technical team leadership • Minimum Qualifications: • Bachelor's degree from an accredited technical college or university in Electrical or Computer Engineering • 10+ years of work experience in electronic product design • Extensive experience with embedded system design, including: • Digital, Analog, and Mixed Signal Design • Board-level communication interfaces (I2C, SPI, UART, RS-232, RS-422, RS-485, CAN) • Controlled impedance for high-speed channel design (SpaceWire, 10GbE, SerDes) • Linear and Switch Mode DC/DC Power Conversion • Documentation (Test Procedures & Reports, Interface Control Documents, ECOs) • Familiarity with: • Design Analysis and Simulation (WCA/WCCA, Reliability, Radiation, Spice) • Cable and Wire Harness Design • Signal and Power Integrity (SI/PI) • Electromagnetic Compatibility (EMC) • Extensive experience in prototype development, debug, and test in a lab environment • Proven experience crafting and launching products in regulated environments • Preferred Qualifications: • Experience crafting motion control and electromechanical systems for space environments • Successful history of leading technical teams and mentoring junior engineers • Experience with: • EEE-INST-002 and radiation-hardness/mitigation • Failure Modes and Effects Analysis (FMEA) • Generation of technical proposal content and labor/cost estimation • Altium Designer • Familiarity with: • DSP and Microcontroller firmware development • Cable and Wire Harness Design • FPGA Design (Verilog and VHDL) • System and functional requirements generation. and/or transports placardable amounts of hazardous materials by ground in any vehicle on a public road while in commerce, may be subject to additional Federal Motor Carrier Safety Regulations including:
• Driver Qualification Files • Medical Certification (obtained before onboarding) • Road Test • Hours of Service • Drug and Alcohol Testing (CDL drivers only) • Vehicle inspection requirements • CDL requirements (if applicable) • Hazardous materials transportation/shipping training.