Mechanical Assembler

Responsible for loading, operating, and unloading rubber press equipment to manufacture products that meet all product specifications, quality standards, and production requirements while minimizing waste and maintaining a safe work environment.

• High School Diploma or GED required.
• 1-2 years of mechanical assembly or manufacturing experience preferred.
• Ability to read and understand engineering drawings, blueprints, schematics, and work instructions.
• Experience using hand tools, power tools, torque tools, and measuring instruments.
• Basic understanding of mechanical components, fasteners, fittings, and assemblies.
• Ability to perform accurate measurements and quality inspections.
• Strong attention to detail, accuracy, and workmanship.
• Ability to troubleshoot basic assembly issues and perform rework when needed.
• Ability to follow SOPs, safety procedures, and quality standards.
• Good communication and teamwork skills.
• Ability to stand for extended periods and safely lift/move materials as required.
• Forklift or other equipment certification may be required depending on the work environment.
• Load raw materials into the press according to established procedures, ensuring proper weight and material distribution for consistent Mold coverage.
• Monitor and operate press equipment to ensure lubrication, temperature, tonnage, and cycle times meet product specifications. Report any equipment issues or process deficiencies to the setup technician or supervisor.
• Maintain a clean, organized, and safe work area by properly disposing of scrap, waste, and other materials in designated locations.
• Ensure cleanliness of equipment and workstations by removing oil, cured scrap, water, and other contaminants that could affect product quality before or after curing.
• Accurately complete production, quality, and process documentation.
• Trim excess material from pads, inspect stoppers for quality defects, and perform necessary corrective actions when defects are identified.
• Process manufactured pads through the cooling unit according to established procedures.
• Stack and place pads or stoppers onto pallets or other designated storage locations.
• Follow all safety policies, environmental procedures, and Quality System Regulations (QSRs) always.