Garage Door Installer

Remove or disassemble defective automatic mechanical door closers, using hand tools.

Complete required paperwork, such as work orders, according to services performed or required.

Cover treadles with carpeting or other floor covering materials and test systems by operating treadles.

Wind large springs with upward motion of arm.

Study blueprints and schematic diagrams to determine appropriate methods of installing or repairing automated door openers.

Set doors into place or stack hardware sections into openings after rail or track installation.

Assemble and fasten tracks to structures or bucks, using impact wrenches or welding equipment.

Cut door stops or angle irons to fit openings.

Repair or replace worn or broken door parts, using hand tools.

Fabricate replacements for worn or broken parts, using welders, lathes, drill presses, or shaping or milling machines.

Bore or cut holes in flooring as required for installation, using hand or power tools.

Lubricate door closer oil chambers and pack spindles with leather washers.

Carry springs to tops of doors, using ladders or scaffolding, and attach springs to tracks to install spring systems.

Prepare doors for hardware installation, such as drilling holes to install locks.

Clean door closer parts, using caustic soda, rotary brushes, or grinding wheels.

Set in and secure floor treadles for door activating mechanisms; then connect power packs and electrical panelboards to treadles.

Inspect job sites, assessing headroom, side room, or other conditions to determine appropriateness of door for a given location.

Fasten angle iron back-hangers to ceilings and tracks, using fasteners or welding equipment.

Install door frames, rails, steel rolling curtains, electronic-eye mechanisms, or electric door openers and closers, using power tools, hand tools, and electronic test equipment.

Operate lifts, winches, or chain falls to move heavy curtain doors.

Run low voltage wiring on ceiling surfaces, using insulated staples.

Collect payment upon job completion.

Adjust doors to open or close with the correct amount of effort or make simple adjustments to electric openers.

Order replacement springs, sections, or slats.

Install dock seals, bumpers, or shelters.